blast drying oven

blast drying oven

1. The box is made of mirror stainless steel (orwire drawing plate) It is made by argon arc welding, and the outside of the box is made of steel plate, which is beautiful and novel.

2. using temperature control protection, digital display microcomputer temperature controller, with timing function, reliable temperature control. (Optional intelligent programmed temperature controller-see right figure)

3. The hot air circulation system is composed of a fan that can operate continuously at high temperature and a suitable air duct, and the temperature in the working room is uniform.

4. Independent temperature limit alarm, more than the limit temperature is automatically interrupted to ensure that the experiment is carried out normally without accidents.

5. With RS4B5 interface can be connected to the recorder and computer, can record the changes of temperature and humidity parameters (optional)

product use

This product is suitable for industrial and mining enterprise laboratories, medical and health, scientific research units for drying, baking, melting wax, sterilization, curing use.

use attention

1. After connecting the power supply, you can turn on the 2 groups of heating switches, and then set the temperature you need to control the instrument. The indicator light is on, and the blower switch can be turned on at the same time to make the blower work.

2. When the temperature rises to the desired temperature, the indicator light goes out. At the beginning of the constant temperature, the temperature may continue to rise, which is the influence of waste heat, and this phenomenon will tend to be stable for about half an hour. In the constant temperature process, with the help of the box thermostat automatic temperature control, without manual management.

3. Constant temperature can turn off a set of heating switch, leaving only a set of electric heater to work, so as to avoid excessive power, affecting the sensitivity of constant temperature.

4. The box should be placed at indoor level.

5. A knife switch with iron shell shall be installed in the power supply line for the special purpose of this box, and the shell shall be grounded.

6. Please check the electrical performance of the box before power on, and pay attention to whether there is open circuit or leakage.

7. When everything is ready, you can put in the test article, close the door and unscrew the exhaust valve at the top. At this time, you can connect the power supply and start working.

8. Do not remove the side door arbitrarily, disturb or change the line, only when the box failure can remove the side door, according to the line one by one inspection.

9. This box is a non-explosion-proof drying box, so it contains flammable and volatile items. Do not put it into the drying box to avoid occurrence.

10. eachdrying box. The average load of each shelf is 15kg. Do not overpack and overload when placing the test article, so as not to affect the convection of hot air. At the same time, do not place the test article on the heat dissipation plate at the bottom of the studio to prevent overheating and damage to the test article.